Surebond 1000 - Permachip PICP Chip Stabilizer (Sample 1 Pint)
- PICP Chip Binder – Minimizes chip loss and scattering
- Immediate, Easy Application
- Clear, Water Based Acrylic
- VOC Complaint
- Durable Natural Finish
- Protective – Guards against surface intrusion of salts and other contaminants, and resists staining
SB-1000 PermStik™ is a hybrid polymer blend designed to bind together granite chips used in permeable paving systems and minimize their loss due to extractive forces from washout, traffic,and pavement sweeping. SB-1000 PermStik™ is a water-based product that exceeds all VOC and EPA standards. SB-1000 PermStik™ is milky white when applied but dries to a clear, natural look. SB-1000 PermStik™ maintains flexibility to accommodate thermodynamic cycling and related movement. Cured product is freeze resistant to -40°F and stable up to a temperature of 150°F.
Assuming 11% void areas and 1” of chip stabilization, coverage rate is 75 – 100 sf per gallon.
*Coverage based on single coat. Some applications may require additional coats. Actual coverage may vary depending on the type, age, condition, joint size and porosity of the surface, application method and other local conditions like temperature and humidity.
TEST FIRST on a small inconspicuous area to determine the suitability and if desired results are achievable with this product on your specific surface. Testing will also determine final coverage rates necessary to adequately bind jointing chips. Paver joints should be properly filled with an approved aggregate such as SEK-Surebond Perm Chips™ and compacted. The surface should be clean and free from oil, dust and any loose material or other contaminants. A leaf blower is recommended to remove dust and fine particles from the surface.If necessary, use Surebond SureClean for general purpose cleaning, following instructions per manufacturer. Use Surebond Efflo-Off, if needed, to remove any efflorescence prior to application. Previously applied sealers should be verified for compatibility or removed. Always ensure complete removal of strippers and cleaners after use by thoroughly rinsing.
Apply when day and night temperatures are between 40°F – 95°F. Avoid windy conditions to keep sealer spray from drifting. Agitate or stir before each use. Spray SB-1000 PermStik™ on the pavement surface, focusing on the joints. Immediately roll or squeegee uniformly into the joints. Remove all surface pooling and as much excess as possible from the top of the pavement. Use coverage guidelines and pre-job testing to determine the correct amount of material necessary to provide adequate adhesion in the joint. Airless sprayers are not recommended for application due to the volume of material applied, but hand held pump sprayers can be used on smaller projects. Use the largest nozzle possible to ensure adequate coverage. Use a low pressure, even spray to wet down the pavement surface and joint material with sealer. Once complete, clean all application equipment with water and do not allow material to dry in spray equipment as removal becomes more difficult. NOTE: Excessive application of the product can cause surface to become slippery.
The surface should be dry to the touch in approximately one hour of application. Ensure that pavement is protected from moisture and traffic for at least 24 hours after application and, although initial drying occurs quickly, complete curing will take additional time. Joints will also begin drying within one hour, but full-depth drying will take greater than 24 hours and will vary depending on temperature and humidity.
For tools and equipment, use soap and water before product is allowed to dry.